Rovers North

This Rubber Floor Mat Set for Series 1 with the Land Rover logo are made to fit all 80" models, whether left or right hand drive, made between 1948 and 1953.

• Easily removed for cleaning
• Will fit all 80" variants from 1948 - 1953, left or right hand drive
• Raised edge border to keep in mud and grime
• The Series front floor mats are supplied in pairs
• Can be cleaned with water and detergent do not use an abrasive brush

To install you need to first clear the handbrake section trimming off by cutting away the lower groove, this allows the handbrake boot to sit very neatly onto the mat surface with the matting lipping underneath the boot.

The same applies to the pedal section, remove either the left hand pedal sections or the right hand depending on model type and the original boots again sit into the mat.

If you have the early chain pull on the right hand floor you need to simply punch a small hole in this thickened area to allow this to pass through the mat.

These are well thought out mats and fit very well and are in keeping with the era.