Rovers North

Speedometer cable assembly. OEM.

FITS: Series II & IIA 1958-1971 all models with threaded cable fitting at speedometer.

NOTE: Series III speedometers look identical to negative earth Series IIA speedometers and were often fitted as replacements to 1967 - 1971 Land Rover models when Series IIA speedometers became NLA. These speedometers use different cables. Series III speedometers use a plastic clip to attach the cable to the speedometer and Series IIA use an alloy threaded barrel nut. The cable assembly needs to match the speedometer. So if you are new to your Land Rover we recommend you check how your cable attaches to the speedometer to determine the correct cable required. For Series III cable assembly use PLT008 or RNT008.

To ensure a long service life it is important that the cable does not sag where it connects into the drive housing on the transfer case. The cable needs to be as straight as possible along the rear of the transfer box and distanced from the exhaust front pipe in route to the dash. Too tight an angle in the cable, or an unsupported sag where it attaches to the transfer box is often detected by a speedometer needle bounce at low speeds.

Fits These Vehicles:

Model:	Notes:
Series II
Series IIA