Front floor mat pair for Defender equipped with LT77 or R380 up to 2007 and the Puma TDCi from 2007 onwards. It is designed to be cut to fit your specific application.
- Easily removed for cleaning
- Chequer plate finish with oval logo
- Will fit either left or right hand drive
- lowered area for throttle pedal clearance
- Raised edge border to keep in mud and grime
- The Defender front floor mats are supplied in pairs
- Will fit all Defenders. 200Td, 300Tdi, Td5 & Tdci (Puma)
- Can be cleaned with water and detergent do not use an abrasive brush
- When placing in the drivers footwell of a 200Td (RH Drive LT77) a gap remains between the tunnel and the mat of about one and a half inch
The kit isn’t complicated to fit, but can require a little bit of patience. To install, before you cut the mat, simply drop the it into place and determine which section you need to remove based on your vehicle type and configuration.
A good old fashioned piece of advice is: measure twice, cut once!!
FITTING GUIDE
Once you have selected the panel to be removed, then cut along the outer raised edge (not the inner) as you need the raised edge to help to trap and dirt and grime on the mat. Shown above is the removal of the main section to convert the mats from fitting LT77 gearbox type to R380 & TDCi
YOU WILL NEED:
Either a sharp knife or a pair of decent scissors
If you are using a sharp knife then a hard surface to cut onto will be a good aid.
Additional Images:
Fits These Vehicles:
| Model: | Notes: |
|---|
| Defender 90 | 2000-2016 w/ LT77, R380 or Puma TDCi |
| Defender 110 | 1983-2016 w/ LT77, R380 or Puma TDCi |
| Defender 130 | 1983-2016 w/ LT77, R380 or Puma TDCi |